ACI Air Wipe | Cable Dryer - High Speed Module

Cable Dryer

Our cable Dryer achieves reduced quality check failure rates as well as lower energy consumption. As a result, the unit achieves major running cost savings and vastly improved cable and wire drying efficiencies. 
Round or flat product profiles, with diameters between 0.2 and 65mm can be successfully dried at maximum line speeds of up to 1,200m/min.

Key Features:
• No compressed air
• Enhanced drying efficiency
• Reduced energy and water consumption
• Lower noise levels

ACI Cable Drying System

 

 

If you would like to discuss the suitability of this system for your application, please contact us.

 

INFORMATION

  • The Cable Dryer is engineered to effectively remove residual moisture from water-cooled insulated wire, cable and extruded products.

  • It is particularly effective in small diameter production where the system enables reliable production rates of up to 1,200 metres per minute.
  • It works by closely focusing powerful angled air jets against the flow of the product. These air jets are aimed at the product to hold back the advancing residual moisture. By breaking the surface tension of the water, it allows it to gather and be removed from the product. Soft-edged flexible rubber baffles help contain the resulting spray, preventing it from exiting the enclosure and thus avoiding spillage and potential health and safety issues.
  • The removed water drains from the enclosure and can be piped back into the system to save consumption, costs and improve processes.
  • The unit is fully enclosed, adjustable and has a footprint of only 950mm long, which enables it to fit easily into most production lines. The system is available with a choice of three different drying modules to suit most applications.

The Power Pack

The cable dryer requires a standalone, lateral channel blower to run.

• 50Hz single-stage blower
• Pressure of up to 600 mbar
• Noise level up to 80 dB(A)
• Suitable for horizontal and vertical
installation
• Pressure configuration available on request

 

Find out more

General Characteristics:

Discharge Figures

Pressures: up to >230In.Swg (8.3PSI)
Air Temperature: up to 100 Degree C (212 Degree F.)

Product Capabilities

Diameter: 0.2 < 65mm
Running speed: up to 1,200m/min

Standard Electrical Supply

3Ph, 400/480V, 50/60Hz
IP55 motor protection

Materials

Ultra High Speed:
Face Plates/End Caps: PTFE
Flexi Hose: High temperature, silicone rubber-coated and reinforced glass fabric
Baffles: Neoprene rubber
Enclosed Seal: Closed cell polyethylence sponge
Rollers: Ceramic

High Speed:
Face Plates/End Caps: PTFE
Flexi Hose: High temperature, silicone rubber-coated and reinforced glass fabric
Baffles: Neoprene rubber
Enclosed Seal: Closed cell polyethylence sponge
Rollers: Stainless steel 304

Standard Plate:
Face Plates/End Caps: PTFE
Flexi Hose: Clear polyurethane (internal) and thermo plastic rubber (external)
Baffles: Neoprene rubber
Enclosed Seal: Closed cell polyethylence sponge
Rollers: POM (Plastic)

Ring Dryer:
Flexi Hose: Clear polyurethane (internal) and thermo plastic rubber (external)
Baffles: Neoprene rubber
Enclosed Seal: Closed cell polyethylence sponge
Rollers: POM (Plastic)

Outline Drawing:

Our Range of Products

+